Operating Instructions
Part No. 70458301ENR7
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 109
2. Set the HEAT TIME for the number of minutes (from 0 -
60) desired.
Figure 31
3. Set the COOL DOWN TIME for the number of minutes
(from 0 - 15) desired.
Figure 32
4. Select reversing or nonreversing cylinder rotation setting, if
applicable.
Figure 33
5. Press and release START button to start tumble dryer.
Display will show minutes remaining before end of cycle.
Figure 34
NOTE: One touch drying is available for repetitive
loads. If the START button is pressed while the
machine is in Idle Mode, when the display is dark,
the tumble dryer will repeat the last drying cycle.
If the cycle time is adjusted before the cycle is
started, the time displayed when the start button
was pressed will be used for future cycles.
IMPORTANT: To stop the tumble dryer at any time
during the cycle, OPEN DOOR. If the loading door
or lint panel door is opened during the cycle, the
heating system will shut off and the motor will
stop. To restart the cycle, both doors must be
closed and the START button must be pressed in.
If the load cools to 90°F (32°C) before cool down time expires,
the control will flash “Lr” (load ready) in the heat time display.
If the door is not opened, the tumble dryer completes the
selected cool down time. If the door is opened after reaching
“Lr” temperature, the cycle will be terminated.
NOTE: If display shows an error code, refer to
Error Codes section.
6. When the cycle is complete, open door and remove the
laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
Anti-wrinkle feature will tumble the load without
heat for 30 seconds every 2 minutes for 1 hour OR
until the loading door is opened.
To Next Page
Loading...
