© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
F8112201
18
Quarterly
NOTE: Disconnect power to washer-extractor
before performing quarterly maintenance
procedures.
1. Tighten door hinges and fasteners, if necessary.
2. Tighten anchor bolts, if necessary.
3. Verify that drain motor shield is in place and
secure.
4. Check all painted surfaces for bare metal.
(Matching gray paint is available from
manufacturer.)
a. If bare metal is showing, paint with primer or
solvent-based paint.
b. If rust appears, remove it with sandpaper or by
chemical means. Then paint with primer or
solvent-based paint.
5. Clean steam filter, where applicable.
a. Turn off steam supply and allow time for
valve to cool.
b. Unscrew nut.
c. Remove element and clean.
d. Replace element and nut.
To Next Page
