To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems BWNBC2PP112TW01 and is the answer not in the manual?
General| Category | Washer |
|---|---|
| Model | BWNBC2PP112TW01 |
| Brand | Alliance Laundry Systems |
| Frequency | 60 Hz |
| Control Type | Electronic |
| Type | Commercial Washer |
| Capacity | 12 kg |
| Height | 43 inches |
| Door Type | Front Load |
| Material | Stainless Steel |
| Width | 26 7/8 in |
Explains the MDC programmable control and its basic functions for owners.
Defines key terms and abbreviations used throughout the manual.
Details how the washer control resumes operation after a power interruption.
Describes the control's communication with third-party card readers.
Explains the function of keypads used to select specific wash cycles.
Details the function of the START keypad for initiating cycles and other operations.
Describes the function of various LEDs indicating cycle status and selections.
Explains how the digital display shows time, price, and codes.
Details the initial display and entry into Ready Mode upon power application.
Explains the state of the control when the washer is ready for cycle selection.
Describes the effect of opening the lid during a cycle and how it resumes.
Outlines the audible signals the washer control can produce.
Overview of how to program cycles, vend prices, and audit information.
Explains how to access and retrieve stored audit data from the washer.
Introduces diagnostic tests for checking washer operations.
Describes how to quickly advance through active cycles or to Ready Mode.
Explains how the control accepts pulses from coin drops to satisfy vend price.
Details how the control accepts pulses from card reader systems.
Explains how accessing doors enables manual operation modes.
Details opening the service door for programming on coin-operated models.
Explains opening the service door and unplugging connectors for card reader models.
Provides the sequence of steps to access the Manual Mode.
Lists the four available features within Manual Mode.
Outlines the types of information and features that can be programmed.
Lists the available options for programming with their descriptions.
Instructions for setting the value for the first coin input.
Instructions for setting the value for the second coin input.
Guide to programming the value of start pulses from card systems.
Instructions for setting the default length for wash cycles.
How to turn ON/OFF preprogrammed capabilities via configuration.
Details on changing configuration values for specific features.
How to set the default wash cycle type for the machine.
Explains the methods to access the audit feature.
Guides the user on scrolling through and viewing audit options.
Procedure for exiting the audit feature when accessed via Manual Mode.
Explains the purpose of specific diagnostic tests like fill and drain times.
Steps to access the testing mode from Manual Mode.
Instructions on initiating a selected diagnostic test.
Procedure to exit the testing mode.
How to enter and perform the production test cycle.
Details how to advance the cycle step-by-step using the START keypad.
Steps to activate Rapid Advance from the Ready Mode.
Procedure to activate Rapid Advance while a cycle is in progress.
Method to exit the Rapid Advance feature.
Specifies the default wash cycle and how its length can be adjusted.
