If the vend price (Vend Price AtS) is set for 200, and the coin
amount is set for 0100, the vend price displayed will decrease by
100 for each coin entered.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad until PrOg appears in the Four-Digit Dis-
play.
Figure 11
3.
Press the START (enter) keypad and AtS will appear in the
Four-Digit Display.
4. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to scroll through the programmable options
until dEn2 appears in the Four-Digit Display.
Figure 12
5.
When dEn2 appears in the Four-Digit Display, press the
START (enter) keypad. There are four digits in Coin #2
Amount, and the fourth digit will become the active digit. The
active digit will flash one second on and one second off.
Figure 13
NOTE: The coin amount can be set from 1 to 9999.
6. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to increase or decrease the value of the ac-
tive digit and the START (enter) keypad to enter the value of
the digit and advance to the next digit.
7. Repeat step 6 for each of the four digits. When the START
(enter) keypad is pressed and the last digit is the active digit,
the changes to the coin #2 amount will be saved into the
memory. The next option, PLSE, will appear in the Four-Digit
Display.
NOTE: To program PLSE (Start Pulse Value), refer to
that section. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Start Pulse Value PLSE
This option allows the owner to program the value of the start
pulse with an aftermarket central card reader or pay system.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad until PrOg appears in the Four-Digit Dis-
play.
Figure 14
3.
Press the START (enter) keypad and AtS will appear in the
Four-Digit Display.
4. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to scroll through the programmable options
until PLSE appears in the Four-Digit Display.
Figure 15
5.
When PLSE appears in the Four-Digit Display, press the
START (enter) keypad. There are four digits in Start Pulse
Value, and the fourth digit will become the active digit. The
active digit will flash one second on and one second off.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
16 Part No. 202713ENR1
To Next Page
Loading...
