Figure 16
NOTE: The start pulse can be set from 1 to 9999.
6. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to increase or decrease the value of the ac-
tive digit and the START (enter) keypad to enter the value of
the digit and advance to the next digit.
7. Repeat step 6 for each of the four digits. When the START
(enter) keypad is pressed and the last digit is the active digit,
the changes to the start pulse value will be saved into the
memory. The next option, CyCL, will appear in the Four-Digit
Display.
NOTE: To program CyCL (Cycle Time), refer to that
section. To program other options, refer to the ap-
propriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Cycle Time CyCL
This option allows the owner to set the length of time for all cy-
cles.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad until PrOg appears in the Four-Digit Dis-
play.
Figure 17
3.
Press the START (enter) keypad and AtS will appear in the
Four-Digit Display.
4. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to scroll through the programmable options
until CyCL appears in the Four-Digit Display.
Figure 18
5.
When CyCL appears in the Four-Digit Display, press the
START (enter) keypad. A two-letter code will appear in the
Four-Digit Display. This code (found below) corresponds to
the cycle time.
SH = Short Cycle
LO = Long Cycle
6. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to increase or decrease the current code
displayed in the Four-Digit Display to the desired code.
7. Press the START (enter) keypad when the correct code ap-
pears in the Four-Digit Display. The next option, CnFg, will
appear in the Four-Digit Display.
NOTE: To program CnFg (Configuration Display), re-
fer to that section. To program other options, refer
to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Configuration Display CnFg
This option allows the owner to turn ON or turn OFF preprog-
rammed capabilities within MDC.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad until PrOg appears in the Four-Digit Dis-
play.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
17 Part No. 202713ENR1
To Next Page
Loading...
