Special Features
Programming Control
The control allows the owner to program the control with the use
of the keypad. Cycle and vend information may be programmed,
audit information may be viewed and diagnostic tests may be run
by pressing keypad combinations.
Collecting Audit Information
With MDC, the washer owner is able to access valuable audit in-
formation by manual access or by a third party card reader. Audit
information recorded and available to be displayed to the owner
includes total coins entered, total start pulses received, and total
cycles.
For detailed information on audit features, refer to Collecting Au-
dit Information.
Testing Machine and MDC Functions
Special diagnostic features built into the control allow the owner
to run specific diagnostic tests. By opening and closing the serv-
ice door and then pressing various sequences of Select Cycle
pads, the owner may perform the following tests:
• Show Fill Time Test
• Show Drain Time Test
• Production Test
For detailed information on running diagnostic tests, refer to Test-
ing Machine and MDC Functions.
Rapid Advance Feature
This feature allows the user to quickly advance through an active
cycle or advance into a cycle from the Ready Mode. This feature
is useful when tests must be performed immediately on a ma-
chine currently in an active cycle. In this case, the user can quick-
ly advance through the cycle to the Ready Mode. At this point,
the user can perform the required tests and then return the ma-
chine to the active cycle.
Coin Drop
The control will accept pulses from a single or dual coin drop to
satisfy vend price. Each coin drop will have the ability to start or
run a cycle.
Start Pulse Operation
The control will accept pulses from a central card reader system
(available at extra cost). The machine can be programmed for the
value of each start pulse received. Refer to Start Pulse Value
PLSE.
Service Door and Coin Vault Openings
An open service door combined with various keypad presses al-
lows the control to enter manual modes of operation. These
modes include Manual Programming, Audit Collection, and Di-
agnostics.
Special Features
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
11 Part No. 202713ENR1
To Next Page
Loading...
