tive digit and the START (enter) keypad to enter the value of
the digit and advance to the next digit.
7. Repeat step 6 for each of the four digits. When the START
(enter) keypad is pressed and the last digit is the active digit,
the changes to the vend price will be saved into the memory.
The next option, dEn1, will appear in the Four-Digit Display.
NOTE: To program dEn1 (Coin #1 Amount), refer to
that section. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Coin #1 Amount dEn1
This option allows the owner to set a specific numerical value for
a coin entered. For example, in the United States, the coin value
for one quarter would be measured in cents (25). Therefore, the
coin amount entered for one quarter would be 0025.
If the vend price (Vend Price AtS) is set for 75, and the coin
amount is set for 0025, the vend price displayed will decrease by
25 for each coin entered.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad until PrOg appears in the Four-Digit Dis-
play.
Figure 8
3.
Press the START (enter) keypad and AtS will appear in the
Four-Digit Display.
4. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to scroll through the programmable options
until dEn1 appears in the Four-Digit Display.
Figure 9
5.
When dEn1 appears in the Four-Digit Display, press the
START (enter) keypad. There are four digits in Coin #1
Amount, and the fourth digit will become the active digit. The
active digit will flash one second on and one second off.
Figure 10
NOTE: The coin amount can be set from 1 to 9999.
6. Press the PERM PRESS/WARM (∧) or the DELICATES/
COLD (∨) keypad to increase or decrease the value of the ac-
tive digit and the START (enter) keypad to enter the value of
the digit and advance to the next digit.
7. Repeat step 6 for each of the four digits. When the START
(enter) keypad is pressed and the last digit is the active digit,
the changes to the coin #1 amount will be saved into the
memory. The next option, dEn2, will appear in the Four-Digit
Display.
NOTE: To program dEn2 (Coin #2 Amount), refer to
that section. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option, not a val-
ue.
2. While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/ WARM keypad with the other
hand. The control will revert back to the previous mode of op-
eration.
Coin #2 Amount dEn2
This option allows the owner to set a specific numerical value for
a coin entered when using the dual coin drop. For example, the
coin value for a dollar coin would be measured in cents (100).
Therefore, the coin amount entered for one dollar coin would be
0100.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. 202713ENR1
To Next Page
Loading...
