Adjusting the feet
Place the washing machine so that it is stable.
1. Level the washing machine in longitudinal and
traverse direction by rotating the adjustable feet
(using a No. 32 spanner).
The feet allow levelling by +/- 1 cm.
2. When the appropriate height of feet is set, use
the wrench No. 17 to firmly fasten the
counter-nuts towards the bottom of the
appliance .
3. Tighten the jam nuts (counter nuts) to the end
position.
This will reduce washing machine noise,
vibration, movement etc. to minimum.
Moving the washing machine and transport after installation
If you are moving the washing machine without packaging, open the washing machine door and pull
the appliance by holding the washing assembly, as indicated in the figure.
For any further moving of the appliance, use the transport rods (the washing machine drum has to be
blocked).
(See chapter TRANSPORT PROTECTION.)
Connection to water supply
INFORMATION!
The machine has to be connected to water supply by an adequately trained person.
Use the water supply hose to connect the appliance. Water pressure has to be between 0.1 and 1
MPa (approximately 1–10 kp/cm
2
, 1-10 bar, 10–100 N/cm
2
).
If the hoses are newly installed, we recommend rinsing them to remove any impurities. Otherwise,
these impurities could clog the filter in the water connection on the washing machine and thus cut off
the water supply.
16
To Next Page
Loading...
