Cleaning and maintenance
Cleaning the filter
The washing machine has a filter that will retain smaller objects such as coins, buttons, hair etc.
1
Before cleaning, drain the water from the washing
machine using the Drain program, and disconnect
the washing machine from the power mains.
Open the pump filter cover using appropriate
tools (emergency door opening tool is located on
the back side of the dispenser).
2
Release the water drain hose from the holder.
Before cleaning the filter, drain the water from
the washing machine by placing the end of the
water drain hose over a large shallow container
and opening the cap on the water drain hose.
3
Gradually rotate the filter in the counter-clockwise
direction and pull it out.
4
Clean the filter thoroughly under running water.
5
Remove all objects and impurities from the filter
housing and the impeller.
6
Replace the filter as shown in the figure and
fasten it by rotating in the clockwise direction.
For a good seal, the filter seal surface should be
clean.
Also re-install the drain hose.
33
To Next Page
Loading...
