Settings
Only appliance owner/distributor may change the settings!
(owner/distributor should check Service manual)
DescriptionSettingOn display
Setting affect all programsno Drain --> max. rpmMax. RPM
Setting of draining via valve or
pump, depending on the type of
appliance; in case of change, a
mechanical change on the appli-
ance is required.
Valve/DrainDrain
In the Disinfection programs and
in the Special programs; this
means displaying the actual
measured temperature in the
drum.
On/OffShow temp
By changing settings it is pos-
sible to create and customize
your own program.
On each program (some set-
tings cannot be set on some
programs)
Change program
Program can be renamed!
On/Off
• Prewash
°C/°F0 --> max
• Change temperature
no Drain --> max. rpm
• Change spin RPM
On/Off
• Water Level
On/Off
• Anti-crease
Once the above changes are
done, you can save the program
as a new program or overwrite
an existing program.
Override existing/Save as new
• Save program
At max. rpm in the Spinning
phase
0 --> 300Spin time
Choose either °C or °F.°C/°FTemperature unit
Additional rinses to the program
are added.
On/OffSuper rinse
With enabled function payment
is requested, to be able to start
the program.
On/OffPayment system
On/Off3D sensor
30
To Next Page
Loading...
