To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems SFNNYRSP116TW01 and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | SFNNYRSP116TW01 |
| Category | Washer |
| Frequency | 60 Hz |
| Control Type | Electronic |
| Material | Stainless Steel |
| Phase | Single Phase |
How the control saves and resumes cycles after power interruptions.
How to pause and resume a running cycle.
How to set up delayed start times for OPL mode.
How to activate delayed start after setup.
Prevents machine use during specific times or for specific users.
Enters low power or off state based on programmed times and options.
How to program cycles, vend prices, and run diagnostics via keypad.
Retrieving stored audit data using keypad combinations.
Running special diagnostic tests on the control.
Allows quick advancement through active cycles or into cycles from Ready Mode.
Communicating with external devices, card readers, or networks.
Signals an alarm if service door or coin vault is opened without disabling.
Allows programming vend prices for specific hours and dates.
Shuts down or enters low power mode based on programmable times.
Step-by-step guide to enter Manual Mode for programming/testing.
Overview of programmable features via keypads or external device.
List of programmable options with display, description, default, and range.
Setting the vend price for Normal Hot cycle.
Setting the vend price for Normal Warm cycle.
Setting the vend price for Normal Cold cycle.
Setting the vend price for Synthetic Hot cycle.
Setting the vend price for Synthetic Warm cycle.
Setting the vend price for Synthetic Cold cycle.
Setting the vend price for Delicate Hot cycle.
Setting the vend price for Delicate Warm cycle.
Setting the vend price for Delicate Cold cycle.
Sets the day or days for a special vend.
Sets vend price for Normal Hot cycle in Special Vend 1.
Sets vend price for Normal Warm cycle in Special Vend 1.
Sets vend price for Normal Cold cycle in Special Vend 1.
Sets vend price for Synthetic Hot cycle in Special Vend 1.
Sets vend price for Synthetic Warm cycle in Special Vend 1.
Sets vend price for Synthetic Cold cycle in Special Vend 1.
Sets vend price for Delicate Hot cycle in Special Vend 1.
Sets vend price for Delicate Warm cycle in Special Vend 1.
Sets vend price for Delicate Cold cycle in Special Vend 1.
Configuring cycle modifiers like Deluxe and Ultra.
Guide to entering cycle programming mode.
Programs the fill steps of a cycle.
Programs the addition of chemicals to the load.
Programs the agitate steps of a cycle.
Programs the soak steps of a cycle.
Programs the drain steps of a cycle.
Programs the extract drain (spin) steps of a cycle.
Resets washer control to factory default settings.
Steps to enter the diagnostic testing mode.
Procedure to enter Factory Test mode.
Errors related to payment systems and communication failures.
Errors for invalid data, no card reader init, or lost communication.
Errors for network issues and water leaks/slow drains.
Errors for max spin speed failure and break-in alarms.
Errors related to fill levels and door lock/open status.
Errors for load balance and door open status.
Errors related to coin input and board identification.
Errors for voltage issues, motor temperature, and IPM faults.
Error when water level is not below empty after draining.
Errors for slow draining and suds detected after routines.
Errors for water leaks, no water flow, and overflow conditions.
Errors related to sensor input, trim, and belt status.
Error if water level rises excessively during leak check.
General errors related to the drive board.
Errors for incorrect input voltage and power failures.
Errors for motor temperature and IPM faults.
Steps to quickly advance through or into a cycle.
Clears control to Ready Mode when satisfying initial vend price.
