Table continued from last page
2
Hold the rib with the other hand and pull it to-
wards you.
3
Lift the drum rib.
4
Remove any objects.
5
Place the rib into the installation slot indicated
with "F" towards you. Make sure all ribs are firmly
in place in their respective slots in the drum. Push
the rib inwards (as indicated by the arrow in the
figure) until it snaps.
If you are using hard water
If you are washing with hard water (causing limescale build-up), a greyish-white film may appear on
the washing machine drum. To remove this film, add vinegar (approximately 2 dl or sodium bicarbonate
“baking soda” (1 tablespoon or 15 g)) into the washing machine drum and select any program with a
temperature of 90 °C, or the Drum Cleaning program. See STEP 5: Choose the program.
Repeat the process as necessary.
36
To Next Page
Loading...
