Alliance Laundry Systems Speed Queen TC5000WN User Manual (English)

Questions and Answers:

M
Mark DavisSep 7, 2025
Why are there too many soap suds in my Alliance Laundry Systems Speed Queen TC5000WN?
- N
  Nicole WaltersSep 7, 2025
  If your Alliance Laundry Systems Washer has too many soap suds, the laundry load may be oversudsing. Ensure you are using a low-sudsing, high efficiency (HE) detergent. Also, make sure you are using the amount of detergent recommended on the detergent’s label. If using non-HE detergent, use only 1/2 of the detergent manufacturer's recommended amount. Finally, ensure the laundry load is not overloaded and that you are using proper load sizes.
T
Terry PowersSep 8, 2025
What does it mean when WASH, RINSE STATUS lights flash 2 times Fill Error on Alliance Laundry Systems Speed Queen TC5000WN Washer?
- J
  John FordSep 8, 2025
  If the WASH and RINSE STATUS lights on your Alliance Laundry Systems Washer are flashing 2 times, indicating a Fill Error, make sure both the hot and cold water faucets are turned on and that the fill hoses aren't kinked or twisted. Clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. As a last resort, unplug the machine for 15 seconds to clear this code.
L
lori65Sep 10, 2025
What does it mean when WASH, RINSE STATUS lights are on continuously Drain Error on Alliance Laundry Systems Speed Queen TC5000WN?
- S
  Sherry CarrollSep 10, 2025
  If the WASH and RINSE STATUS lights on your Alliance Laundry Systems Washer are continuously on, indicating a Drain Error, check the drain hose and drain receptacle to ensure they are properly installed and not blocked. If the issue persists, unplug the machine for 15 seconds to clear the code.
W
William JonesSep 12, 2025
What does WASH, RINSE STATUS lights flash 1 time Pressure Sensor Error mean on Alliance Laundry Systems Speed Queen TC5000WN?
- T
  Thomas RobertsSep 12, 2025
  If the WASH and RINSE STATUS lights on your Alliance Laundry Systems Washer are flashing one time, indicating a Pressure Sensor Error, unplug the machine and call for service.
D
David KellySep 13, 2025
What does WASH, RINSE STATUS lights flash 2 times No Water Flow Error mean on Alliance Laundry Systems Speed Queen TC5000WN?
- K
  kennethgrantSep 13, 2025
  If the WASH and RINSE STATUS lights on your Alliance Laundry Systems Washer are flashing 2 times, indicating a No Water Flow Error, make sure the hot and cold water faucets are turned on, and the fill hoses are not kinked or twisted. Clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. If the issue continues, unplug the machine for 15 seconds to clear the code.