Alliance Laundry Systems UWL045T3V - Preliminary Information; About the Control

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
11
F8434101
Preliminary Information
About the Control
The UniLinc control on the machine is an advanced,
graphical, programmable computer that lets the owner
control most machine features by interacting with the
control.
UniLinc allows the owner to program custom cycles,
run diagnostic cycles and retrieve audit, error and
bearing information.
Machines shipped from the factory have default cycles
and wash temperature settings built in. The owner can
change the default cycles or any cycle.
IMPORTANT: It is extremely important that the
machine has a positive ground and that all
mechanical and electrical connections are made
before applying power to or operating the machine.
Power Failure Recovery
If a cycle is in progress when the power fails, and if
the power outage lasts three or more seconds, the cycle
is lost and cannot be resumed when power recovers. If
the power outage lasts less than three seconds, the
control will resume the cycle when the power
recovers.
IR Communications
The control has the ability to communicate with a
PDA or PC with an IrDA device running the UniLinc
software. Devices such as PDAs and PCs that are
IrDA capable (able to transmit information to
machine) that have been tested and approved for use
with the UniLinc software can be used as a tool for
managing the machine.
Network Communications
The control has the ability to communicate through a
network. The network link allows the user to program,
collect data, and run diagnostics on any machine in the
network from a central location.
Audit Information
The control collects and stores audit information,
which can be accessed with a PC/PDA or through the
network. Refer to the following list for available audit
information.
• Total Number of Individual Cycle Counters
• Last 25 Machine Cycles
• Service History
• Machine Errors Audit Data
• Communication Audit Data
• Re-Programming Audit Data
• Power Failures Audit Data
• Average Fill Time Audit Data
• Average Drain Time Audit Data
• Power Failure Audit Data
The PC/PDA or the network can receive audit and
program data from the control, and send programming
data and diagnostic commands to the control.
Refer to UniLinc PC and PDA Application User
Instructions for additional information on using a PC/
PDA.