Alliance Laundry Systems UWN045K2M - Operation; Operating Instructions for Unilinc Control

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
41
F8410701 (EN)
Operation
Operating Instructions for
UniLinc Control
1. Verify display shows the Cycle Menu Screen.
2. Turn door handle clockwise and open door.
3. Load to capacity whenever possible. DO NOT
OVERLOAD.
Underloading can cause out-of-balance
conditions that can shorten machine life.
NOTE: When washing items which may
disintegrate or fragment, such as mop heads or
sponges, use laundry nets to prevent drain
blockage.
IMPORTANT: To prevent out-of-balance
conditions, premature wear or damage to machine
when using laundry nets, use several small nets in a
load.
4. Close the door.
5. Add dry supplies to the supply dispenser
compartment cups prior to the start of each cycle.
Liquid supplies can be injected directly into the supply
dispenser by an external chemical supply system.
NOTE: Supply dispenser compartment cups must
not be removed when an external chemical
injection supply system is attached to the machine.
6. Press or keypads to select desired
wash cycle.
7. Press to start the selected cycle.
PHM702N
Figure 28
PHM855N
Figure 29
For Technical Service
Distributor ABC
1-800-555-5555
Cycle41:
Supply Set
Up
Cycle02:
Towels White
Cycle01:
Towels
White
Bleach
Cycle Menu
PHM856N
Figure 30
PHM856N
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
SW025
CAUTION