806221 73
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must
be
re
connected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
39. Washer Door Catch
NOTE: When repairing a broken or inoperative No.
802803 Door Catch, proceed as follows:
a. Open loading door.
b. Remove 11 T-20 Torx head screws holdin
g
outer
door bezel to inne
r door bezel. Refer to
Figur
e 6.
c. Pull hinge side of outer beze
l away from door
and slide forward. Refer
to Figure 6.
d. Remove two screws and nuts holding do
or
catch
to door and remove door catch.
e. Install new door catch and tighten screws and
nuts to the point of being snug.
f. Adjust door catch so the outside
edge is
aligned with the edge of
the lock. Refer
to
Figur
e 7.
g. Visually check that the door catch proper
ly
en
gages the funnel of the door latch/switch
assembly. Refer to Figure 7.
h. Recheck the alignment in step “f”. Adjust
if
needed.
i.
Torque the two nuts to
approximately 20 inch
po
unds (2.25 Nm).
j. Reinstall outer door bezel by aligning out
er
bezel tabs with c
ut aways on inner bezel an
d
slidi
ng outer bezel into position. Refer to
Figure 6.
k. Replace 11 screws holding
outer door bezel to
in
ner door bezel.
IMPORTANT: Do not overtighten screws or bezel
holes will strip.
Figure 6
Outer Bezel
Tab
Inner Bezel
Cut Away
To Next Page
Loading...