To Next PageTo Next PageWhat to do if there is a flame without call for heat in my ALLIANCE 120?
To address a flame occurring without a call for heat in your ALLIANCE Dryer, begin by troubleshooting according to the Fault conditions table. Also, inspect the system wiring.
What to do if my ALLIANCE Dryer has an ignition lockout?
If your ALLIANCE Dryer experiences an ignition lockout, troubleshoot the issue using the Fault conditions table.
What to do if I get a manual reset error on my ALLIANCE 120?
If you encounter a manual reset error with your ALLIANCE Dryer, troubleshoot the issue using the Fault conditions table.
What to do if my ALLIANCE Dryer shows an internal control failure?
To resolve an internal control failure in your ALLIANCE Dryer, troubleshoot the issue using the Fault conditions table.
Defines DANGER, WARNING, CAUTION, IMPORTANT, and NOTE statements.
Emphasizes common sense and caution for safe operation and maintenance.
Lists 17 basic precautions for safe operation of the tumble dryer.
Guide on inspecting the unit for damage before installation.
Specifies requirements for the installation location of the tumble dryer.
Details requirements for the fire suppression system.
Outlines the water supply specifications for the fire suppression system.
General advice on venting to prevent fire and ensure efficiency.
Requirements for installing the gas service line.
Warning regarding L.P. gas installation and venting.
Important notes for electrical connections by qualified personnel.
Essential procedures for proper electrical grounding.
Requirements for steam pressure and piping.
Warning regarding shut-off valves for steam components.
Warnings related to fire hazards during operation.
Instructions for cleaning the lint screen and compartment.
Table listing error codes, definitions, and corrective actions.
Guide on adjusting the air shutter for proper burner flame.
Daily checks and cleaning procedures for the tumble dryer.
Steps for performing the fire suppression system test every three months.
Table of common issues and their possible causes/corrections.
General