Reinstallation of Shipping
Materials
You must install the shipping brace and shipping
plug any time the washer is moved.
Shipping Brace
The shipping brace in the lid opening should be
saved and reinstalled whenever the washer is
moved. To reinstall the brace, open the washer
lid and place the brace over the washer
agitator, placing the back of the brace into the
washtub first.
Shipping Plug
The plastic shipping plug should be saved and
reinstalled any time the washer is moved. The
plug fits into two openings: The base opening
and the shipping plug opening on the bottom of
the mobile pivot dome. The plug MUST be
inserted into both openings to prevent
damage to the washer, in order to accomplish
this, the shipping plug opening must De
directly lined up with the base opening. Refer
to illustrations below.
After the shipping brace has been installed in
the lid opening, tilt washer back enough to
access base opening.
Insert shipping plug into base opening and,
using the palm ofyour hand, push shipping plug
into washer until it snaps into shipping plug
opening.
Motor Overload Protector
The internal motor overload protector will
stop the motor automatically if there are too
many clothes in the washtub or ifa failure has
occurred within the machine. The overload
protector will reset itself in two or three
minutes and the motor will restart
automatically, if the overload protector stops
the motor again, remove the washer from use
and call the service person to correct the
problem.
Shipping
Brace
Shipping
Plug Opening
Base
Opening
Shipping
Plug
TLW2044N
-17-
202q47
@Copyright, Alliance Laundry Systems LLC --DO NOT COPY or TRANSMIT
To Next Page
Loading...
