Troubleshooting
Try these troubleshooting tips before making a
service call. You may save time and money!
Washer Symptom Possible Cause / Solution
Won't Fill • Make sure power cord is plugged all the way into the electrical outlet.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Pulltimer knob out to start washer.
• Make sure that the controls are properly set.
• Make sure that the last spin has beencompleted.
• Check the house fuse or circuit breaker.
• Cleanthe screens inthe water mixing valve and the filter screens located at the faucet end
of the fill hoses. (Owner is responsible for service calls regarding cleaning of the screens.)
• Water is being siphoned from the washer during the cycle. Refer to the Installation
instructions to make sure that the drain hose has been properly installed.
WOn;tsta_ Make sure id is Closed:
Puiltimer knob out to sta_ Washer.
MaResure power Cord iS pluggecl ail the Wayinto the electrical Outlet.
Make sure that the controls are pr0perly set.
check the hOUSefuse ore rcut breaker.
Themotor overlOad protector may have stopped the cycle It Wil!reset itself n two or three
minutes and restart the washer automatically.
Won't Agitate • Make sure lid isclosed.
• Pulltimer knob out to start washer.
• Make sure power cord is plugged all the way into the electrical outlet.
• Check the house fuse or circuit breaker.
• The motor overload protector may have stopped the cycle, it will reset itself in two or three
minutes and restart the washer automatically.
• Broken drive belt. Callthe service person.
Make sure power Corcl is plugged all the way into the electrical outlet.
, Check the house fuse or circuit breaker.
.... The motor overload protector may have stoppecl the cycle. It will reset it self in two or three
m!nu,es and restart the washer automatically. ..................................................................
Br°ken dr!ve belt' Cal! the serv!ce pers°n
Stops/Pauses Durinc Cycle • Pauses are part of the washer's normal operation. Thewasher will stop (pause) shortly
before the wash and rinse spins.
• Check the house fuse or circuit breaker.
• The motor overload protector may have stopped the cycle, it will reset itself in two or three
minutes and restart the washer automatically.
Won't Drain , Make Sure clrain hose iSnot kinkecl or twisteal
Make sure dra n hose s not Cogged
' Make sure dra n receptac e SnotC 0ggecl
Refer tothe lnstailal_ion inStructions t0 make sure that the drain hose has been properly
installed:
continued
-19-
202147
@Copyright, Alliance LaundrySystems LLC--DONOTCOPYor TRANSMIT
To Next Page
Loading...
