Sy=pto=
Water Leaks • Check that fill hoses are properly installed on the faucets and the washer's water mixing
valve.
• Replace the fill hoses every five years.
• Make sure drain receptacle is not clogged.
• Check house plumbing.
• Laundry load may be oversudsing or overloaded. Use less detergent (or low-sudsing
detergent) and proper load sizes.
lsNoiSY, wash !oad maY be unba!ancea;Ope_
• Make sure washer is !eve]. Uneven levding CanCause v brat!on.
• A newly installed Washer may make a knocking Sound fthe machine has been in storage. The
belt may have settled: Run Washe_through 4-5 CYClesto loosen belt, Washer operation Will
not be affected
Load is TooWet • Wash load may be unbalanced. Open lid and redistribute the load.
• Load is too small. Add items to make full load.
• Make sure the correct spin speed is selected for the type of items being washed (if option is
available on your model).
Wrong WaterTemperatur e , Make su_e ,hat the
_ CheckfJ]l hoses: Make sure hot faucet hose jS connected to hot mj×ing va!ve (Jnd!cated with
!IH'on the valve bracket) and cold faucet is connected to C_ld mixing valve (indicated With !'Ci
_a!_ebracket),
• Make sure house water heater is adjusted properly.
LowWater Levelon Extra • Starting January 2009, the Department of Energy (DOE) mandated new efficiency
Large Setting standards which resulted in reduced water levels in the topload washer.
-20-
202147
@Copyright, Alliance LaundrySystems LLC--DONOTCOPYor TRANSMIT
To Next Page
Loading...
