To Next Page

To Previous Page

Igniter Glows but Burner Does Not Ignite (Gas Dryer Models)

Did flame sensor fail

in closed position?

Is secondary coil or

holding coil open?

Replace sensor.

Yes

Is gas supply

insufficient?

Replace gas valve

coils. Refer to Dryer

Test Procedures

section

Yes

Are igniter and

bracket improperly

installed on burner

tube assembly?

Check gas supply and

pressure. Make sure

gas shutoff valve is

turned on.

Yes

Is sensor improperly

installed on burner

housing?

Loosen screw and

properly position

igniter and bracket

on burner tube

assembly.

Yes

Loosen screw and

properly position the

sensor on the burner

housing.

Yes

Dryer Troubleshooting

DO NOT COPY or TRANSMIT

25 Part No. D515519R3

ALLIANCE STEBXASP434AW12 User Manual

Questions and Answers: