ALLIANCE T30 Series User Manual

22 70291301
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
9. Clothes Do Not Dry
Clothes Do Not
Dry
Is there
enough heating
time allocated for
the load?
Yes
Is the burner
igniting?
Start cycle again
with enough time to
dry load.
No
Refer to
Burner Does Not
Ignite flowchart.
No
Remove excess
water.
Is
the clothes
load too
large?
Yes
Remove part of
load. Maximum
load is 30 pound
dry weight (cotton
load) for 30 pound
Tumbler, etc.
Is the
exhaust system
improper or
inadequate?
Yes
Refer to Installation
Manual for exhaust
system equirements.
No
Is
the voltage
incorrect?
No
Refer to
Burner Ignites
and Goes Out
Repeatedly
flowchart.
Yes
Set selector
for higher
setting.
Yes
Refer to Installation
Manual for electrical
requirements.
Yes
Is there
inadequate
make-up
air?
Yes
Refer to Installation
Manual for make-up
air requirements.
Is the
exhaust duct to
the outside
blocked?
Yes
Clean duct to
remove blockage.
Is
the drying
selector
improperly
set?
Does
the burner ignite
and go out
repeatedly?
No
No
No
TMB2210S-a
No
Continued on
next page
Is there
too much water in
articles being
dried?
Yes
No
Yes
No

ALLIANCE T30 Series Specifications

General

Brand	ALLIANCE
Model	T30 Series
Category	Dryer
Language	English