42
A. Lowering the equipment on the slope:
1. Set the throttle on the tractor for the required engine
speed. Operator experience is required for this
operation so that the load is carefully controlled.
2. Keep the winch wire rope tightened between the tractor
and the equipment being lowered down the slope. Use
the power control lever in the LINE-OUT position to
control the lowering of the equipment down the slope.
3. Move the power control lever between LINE-OUT
and BRAKE-ON if inching is required. Use minimum
inching to prevent additional heat and wear.
B. Raising the equipment on the slope:
1. Set the throttle on the tractor for the required engine
speed. Operator experience is required for this
operation so that the load is carefully controlled.
2. Keep the winch wire rope tightened between the tractor
and the equipment being lowered down the slope.
Use the power control lever in the LINE-IN position to
control the raising of the equipment down the slope.
3. Move the power control lever between LINE-IN and
BRAKE-ON if inching is required. Use minimal inching
to prevent additional heat and wear.
4. Keep the equipment being raised in alignment with the
winch and tractor. Do not permit the winch wire rope
to loosen and pass under the drive wheels or tracks
of the tractor.
To Next Page
Loading...
Need help?
General
