Allied Telesis AT-GS924MX - Monitoring the Initialization Processes

AT-GS900MX Series Installation Guide for VCStack
97
Monitoring the Initialization Processes
You may monitor the initialization sequence of the stack by connecting a
terminal or computer that has a terminal emulator program to the Console
port on any switch in the stack. You will see the messages in Figure 49
here to Figure 51 on page 99.
Figure 49. Switch Initialization Messages
Bootloader 3.0.10 loaded
Press <Ctrl+B> for the Boot Menu
Reading filesystem...
Loading flash:gs900-5.4.4E-0.1.rel...
Verifying release... OK
Booting...
Starting base/first... [ OK ]
Mounting virtual filesystems... [ OK ]
______________ ____
/\ \ / /______\
/ \ \_ __/ /| ______ |
/ \ | | / | ______ |
/ \ \ / / \ ____ /
/______/\____\ \/ /____________/
Allied Telesis Inc.
AlliedWare Plus (TM) v5.4.4E
Current release filename: gs900-5.4.4E-0.1.rel
Original release filename: x310-5.4.4E-0.1.rel
Built: Wed Jan 14 13:42:17 NZDT 2015
Mounting static filesystems... [ OK ]
Checking flash filesystem... [ OK ]
Mounting flash filesystem... [ OK ]
Checking for last gasp debug output... [ OK ]
Checking NVS filesystem... [ OK ]
Mounting NVS filesystem... [ OK ]
Starting base/dbus... [ OK ]
Starting base/syslog... [ OK ]
Starting base/loopback... [ OK ]