Need help?Do you have a question about the Allied Telesis AT-GS950/10PS and is the answer not in the manual?
General| Product Type | Managed Switch |
|---|---|
| Ports | 10 |
| Port Type | Gigabit Ethernet |
| PoE Ports | 8 |
| PoE Standard | IEEE 802.3af/at |
| PoE Budget | 130W |
| Switching Capacity | 20 Gbps |
| Forwarding Rate | 14.88 Mpps |
| Layer | Layer 2 |
| MAC Address Table Size | 8K |
| Jumbo Frame Support | 9KB |
| Power Supply | Internal |
| Input Voltage | 100-240V AC |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 90% non-condensing |
Explains the safety symbols used throughout the document.
Provides a step-by-step guide to initiating a CLI session.
Command to reset or restart the switch.
Command to restore all switch settings to factory defaults.
Command to reset settings, excluding IP configuration.
Command to save current configuration for permanent storage.
Command to manually assign an IPv4 management address to the switch.
Activates the BOOTP client to obtain an IPv4 address.
Activates the DHCP client to obtain an IPv4 address.
Enables/disables the IPv6 DHCP client for address acquisition.
Command to manually assign an IPv6 management address.
Assigns a link-local IPv6 address to the switch.
Enables automatic assignment of an IPv6 link-local address.
Enables IPv6 address processing on the switch.
Assigns an IPv6 gateway address to the switch.
Disables IPv6 address processing on the switch.
Activates the HTTPS server for secure web management sessions.
To Next Page