Chapter 4: IPv6 Management Address Commands
48
NO IPV6 ENABLE
Syntax
no ipv6 enable
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to disable IPv6 address processing on the switch. This
is the default setting. The switch retains its IPv6 address configuration, but
it stops processing IPv6 management functions. You cannot modify the
IPv6 address configuration on the switch when IPV6 processing is
disabled. To enable IPv6 address processing, refer to “IPV6 ENABLE” on
page 46.
Confirmation Command
“SHOW IPIF” on page 37
Example
This command disables IPv6 address processing:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# no ipv6 enable
To Next Page
Loading...
