GS950 PS Series Command Line Interface User’s Guide
47
IPV6 GATEWAY
Syntax
ipv6 gateway
ipv6_address
Parameters
ipv6_address
Specifies an IPv6 gateway address for the switch. The address is
entered in this format:
nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn
Where N is a hexadecimal digit from 0 to F. The eight groups of digits
have to be separated by colons. Groups where all four digits are ‘0’ can
be omitted. Leading ‘0’s in groups can also be omitted. For example,
the following IPv6 addresses are equivalent:
3710:421e:09a8:0000:0000:0000:00a4:1c50
3710:421e:9a8::a4:1c50
Mode
Global Configuration mode
Description
Use this command to manually assign an IPv6 gateway address to the
switch. The gateway address must be in the same subnet as the switch’s
IPv6 management address and must be assigned after the switch has a
management address. You must enable IPv6 address processing to
assign the switch a gateway address. For instructions, refer to “IPV6
ENABLE” on page 46.
Confirmation Command
“SHOW IPIF” on page 37
Example
This example assigns the switch the IPv6 gateway address
3710:17a9:11::190:a1d4:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# ipv6 gateway
3710:17a9:11::190:a1d4
To Next Page
Loading...
