Allied Telesis AT-GS950/10PS - IPV6 AUTOMATIC LINK-LOCAL ADDRESS

GS950 PS Series Command Line Interface User’s Guide
45
IPV6 AUTOMATIC LINK-LOCAL ADDRESS
Syntax
ipv6 automatic link-local address enable|disable
Parameter
enable
Automatically assigns an IPv6 link-local address to the switch.
disable
Disables the automatic assignment of an IPv6 link-local address.
Mode
Global Configuration Mode
Description
Use this command to have the switch automatically assign itself an IPv6
local link address. To manually set the address, refer to “IPV6 ADDRESS
LINK-LOCAL” on page 44.
You must enable IPv6 address processing on the switch before using this
command. For instructions, refer to “IPV6 ENABLE” on page 46.
Confirmation Command
“SHOW IPIF” on page 37
Example
This example automatically assigns an IPv6 local link address to the
switch:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# ipv6 automatic link-local
address enable
This example disables the automatic assignment of an IPv6 local link
address:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# ipv6 automatic link-local
address disable