Allied Telesis AT-GS950/10PS

To Next Page

To Previous Page

Chapter 4: IPv6 Management Address Commands

IPV6 ENABLE

Syntax

ipv6 enable

Parameters

None.

Mode

Global Configuration mode

Description

Use this command to enable IPv6 address processing on the switch. You

must enable IPv6 address processing to assign the switch an IPv6

address configuration. To disable IPv6 address processing, refer to “NO

IPV6 ENABLE” on page 48.

Confirmation Command

“SHOW IPIF” on page 37

Example

This command enables IPv6 address processing:

ATGS950_28PS# configure terminal

ATGS950_28PS(config)# ipv6 enable

Allied Telesis AT-GS950/10PS - IPV6 ENABLE