Allied Telesis AT-GS950/10PS - Upload

Chapter 6: File Transfer Commands
58
UPLOAD
Syntax
upload cfg_toTFTP ipadd | ipv6addr path_filename
Parameters
ipaddr
Specifies the IPv4 address of a TFTP server on your network.
ipv6addr
Specifies the IPv6 address of a TFTP server on your network.
path_filename
Specifies the path and filename where the TFTP server is to store the
configuration file. The filename cannot contain spaces and must
include the extension “.cfg”. You can specify only one path and
filename.
Mode
Privileged Exec mode
Description
Use this command to upload the configuration file from the switch to a
TFTP server on your network.
Note
The switch must have an IPv4 address to access a TFTP server with
an IPv4 address. The switch must have an IPv6 address to access a
TFTP server with an IPv6 address.
Example
This example uploads the switch’s configuration file and stores it as
“west_unit.cfg” on a TFTP server with the IP address 149.22.121.45:
ATGS950_28PS# upload cfg_totftp 149.22.121.45
west_unit.cfg