Chapter 7: SNMP Commands
64
NO SNMP-SERVER HOST
Syntax
no snmp-server host
ipv4_address
|
ipv6_address
Parameters
ipv4_address
Specifies the IPv4 address of a trap receiver.
ipv6_addr
Specifies the IPv6 address of a trap receiver.
Mode
Global Configuration mode
Description
Use this command to delete IP addresses of trap receivers. You may
delete only one IP address at a time.
Example
This example deletes the IPv4 address 149.44.12.44 of a trap receiver:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# no snmp-server host 149.44.12.44
To Next Page
Loading...
