Chapter 3: IPv4 Management Address Commands
34
CONFIG IPIF SYSTEM BOOTP
Syntax
config ipif system bootp
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to activate the BOOTP client so that the switch
receives an IPv4 management address from a BOOTP server on your
network. The switch automatically queries the network for a BOOTP
server when you activate the client or whenever you reset or power cycle
the switch.
The switch can have only one IPv4 management address.
To manually assign the switch an IPv4 address, refer to “CONFIG IPIF
SYSTEM” on page 32.
The switch reverts to its default IP address, 192.168.1.1, if it does not
receive a response from the BOOTP server after one minute.
Confirmation Command
“SHOW IPIF” on page 37
Example
This example activates the BOOTP client on the switch:
ATGS950_28PS# configure terminal
ATGS950_28PS(config)# config ipif system bootp
To Next Page
Loading...
