Chapter 4: IPv6 Management Address Commands
44
IPV6 ADDRESS LINK-LOCAL
Syntax
ipv6 address
ipv6_address
link-local
Parameter
ipv6_address
Specifies an IPv6 local link address for the switch. The address is
entered in this format:
nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn
Where N is a hexadecimal digit from 0 to F. The eight groups of digits
have to be separated by colons. Groups where all four digits are ‘0’
can be omitted. Leading ‘0’s in groups can also be omitted. For
example, the following IPv6 addresses are equivalent:
3710:421e:09a8:0000:0000:0000:00a4:1c50
3710:421e:9a8::a4:1c50
Mode
Global Configuration Mode
Description
Use this command to assign an IPv6 local link address to the switch. The
device can have only one IPv6 local link address.
You must enable IPv6 address processing on the switch before assigning
an IPv6 local link address. For instructions, refer to “IPV6 ENABLE” on
page 46.
Confirmation Command
“SHOW IPIF” on page 37
Example
This example assigns the switch the IPv6 local link address
3710:17a9:11::190:a1d4:
ATGS950_28PS# ipv6 address 3710:17a9:11::190:a1d4
link-local
To Next Page
Loading...
