Allied Telesis AT-GS950/10PS - RESET CONFIG EXCEPT IP

Chapter 2: Basic Management Commands
28
RESET CONFIG EXCEPT IP
Syntax
reset config except ip
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to restore the default settings to all the parameters on
the switch, except for the IPv4 and IPv6 addresses.
Caution
This command resets the switch. The device will not forward
network traffic while it initializes its management software. Some
network traffic may be lost.
Note
This command does not display a confirmation prompt.
To resume managing the switch, start a new management session.
Example
This example returns all parameter settings, excluding the IP addresses,
to their default settings:
ATGS950_28PS#
reset config except ip