Compare tab
• Select sensor
All sensors can be selected as a reference.
• Condition
Operators: `<= = >= > <>
• Select a comparison sensor
It can be selected between sensor or constant.
• Constant
Values can be entered with or without commas.
• How many seconds must the event exist,...
Time in seconds that the condition must be fulfilled continuously before the action is executed.
Default: 0 seconds.
• Run only at valid value
The action should only be executed if all operators involved in the comparison provide a valid value.
Default: Activated. This is intended for the event, for example, that the cable connection to a
temperature sensor is interrupted. The sensor provides a value that signals minimum temperature.
The condition for the action "heating" is met but little sense, since it would no longer be switched
off.
To Next Page
Loading...