27
http://www.alltraxinc.com
E-Z-GO PDS CONVERSION
J1 - For an indepth pinout of each
connector see pages 22-23. Factory 3
pin speed sensor harness not used in
AC conversions.
J1 - Main wire harness connector
J2 - Personality Switch
J3 - AC Motor case ground
J4 - Can Bus
J5 - Programming port (USB A)
B+ Positive from Solenoid
B- Battery Negative
R Large resistor connection
U U of the Motor
V V of the Motor
W W of the Motor
To Next Page
Loading...
