28
AC OPERATORS MANUAL
PROGRAMMING THE CONTROLLER
Controllersorderedforstockcongurationcomepre-programmed
and do not need to be programmed before use. If the user would
like to customize their performance or has upgraded their motor
and needs a matching motor map the controller can be connected
to a computer with a USB A to B, commonly referred to as a
“printer cable”.
The USB A to B cable is used to connect your
motor controller to your personal computer.
Using the free Allrax Toolkit you can customize
your performance to match your needs.
The Alltrax Toolkit software can be
downloaded from:
https://alltraxinc.com/ac-toolkit-software/
No purchase necessary
To Next Page
Loading...
