Alltrax AC1 - Blink Codes; Normal Display Status; Error Codes

30
AC OPERATORS MANUAL
Normal Display Status:
Solid Green Light = Controller Ready to Run
Solid Red Light = Controller in programming mode
Solid Yellow Light = Throttle is wide open and the controller is
NOT in Current Limit
Blinking Yellow Light = Throttle is wide open, but the controller is in
Current Limit
Error Codes:
ACalarmcodesashasequenceofgreenthenred.Allalarmsareselfclearing
and will repeat until the error condition has been corrected.
1 Green and 1 Red LED Flash = Short Circuit/Output Fault
1 Green and 2 Red LED Flash = Battery Under Voltage
1 Green and 3 Red LED Flash = Battery Over Voltage
1 Green and 4 Red LED Flash = Over temperature
1 Green and 5 Red LED Flash = Throttle Power Fault
1 Green and 6 Red LED Flash = Pre-Charge Failure
2 Green and 1 Red LED Flash = Throttle/Brake Range
2 Green and 2 Red LED Flash = Bad Variables
2 Green and 3 Red LED Flash = High Throttle Over range
2 Green and 4 Red LED Flash = High Throttle Under range
2 Green and 5 Red LED Flash = Low Throttle Over range
2 Green and 6 Red LED Flash = Low Throttle Under range
3 Green and 1 Red LED Flash = Throttle/Brake Range
3 Green and 2 Red LED Flash = Bad Variable Set Loaded
3 Green and 3 Red LED Flash = Relay Coil Overcurrent
3 Green and 4 Red LED Flash = Brake Coil Overcurrent
3 Green and 5 Red LED Flash = Reserved Overcurrent*
3 Green and 6 Red LED Flash = Horn Overcurrent
4 Green and 1 Red LED Flash = Reserved
4 Green and 2 Red LED Flash = Reserved
4 Green and 3 Red LED Flash = Hardware Failure
4 Green and 4 Red LED Flash = Startup Failure
4 Green and 5 Red LED Flash = Reserved
4 Green and 6 Red LED Flash = Reserved
5 Green and 1 Red LED Flash = General Error
BLINK CODES