PAGE 19 ALMAC s.r.l.
Warning: the chassis must be completely lowered (chassis wide)
Attention: Do not excessively tighten the fixing straps to avoid damaging the
structure.
2.5 Checks on the machine before each use
• Visually check under and around the machine to make sure that there are no
oil or fuel leaks. If leaks are discovered, follow the MAINTENANCE
instructions.
• Make sure that there is no hydraulic oil leaking from the hoses and from the
other components (cylinders, distributors, fittings, etc.).
• Check that there are no cut or worn electrical cables and that the connectors
are correctly secured.
• Check the fuel level before starting so as to prevent interruptions while
working.
• Check the engine oil level.
• Check the hydraulic oil level.
• Do not run the engine in closed areas like garages or similar. The engine
exhaust gas contains carbon monoxide, a poisonous gas that can quickly
saturate a closed space and cause difficulties or even death.
• Check that no screw, bolt or ring nut is loose or missing.
• Make sure that all the pins are in place and correctly secured.
• Check that the steel structure is not deformed.
• Make sure there are no cracks in the welds, damage or abnormal wear.
• Make sure the tracks are not cut or abnormally worn.
To Next Page
Loading...
