ALMAC MULTI-LOADER 6.0 - Page 20

PAGE 20 ALMAC s.r.l.
• Always check to make sure that track tension is correct.
• Check that the manual, the plates and the stickers are on the machine.
2.6 General safety instructions on use of the machine
The instructions given below must be followed.
• It is forbidden to work near high voltage overhead electric power lines.
Moreover, the control stations must always be kept at a safety distance of at
least 5 m from cables. For voltages greater than 132KV, refer to the table
below.
Nominal voltage (kV)
Minimum distance (m)
≤ 1
3
1 < Un ≤ 30
3.5
30 < Un ≤ 132
5
> 132
7
• Do not use the machine during storms. You could be struck by lightning.
• Use the machine only in the temperature range permitted.
• It is forbidden to exceed the machine's capacity.
• It is forbidden to use the machine on soft, slippery or non-consistent soils.
Type of terrain, geomorphological
characteristics
Permitted surface pressure
Loose non-compact soil
In general, not solid; requirement for
particular measures
Mixed, compact soil, sand and gravel
2.0 kg/cm² 0.2 N/mm²
Semi-solid cohesive soil
1.0 Kg/cm² 0.1 N/mm²
Solid cohesive soil
2.0 Kg/cm² 0.2 N/mm²
Hard cohesive soil
4.0 Kg/cm² 0.4 N/mm²
Rock, concrete, road paving suited to the
transit of heavy vehicles
Over 10.0 Kg/cm² over 1 N/mm²
2.7 Safety indications on the use of the travel function
The instructions given below must be followed.
• Make sure movements are done on flat, sturdy ground.
• Make sure that there are no hollows or ridges in the floor and that there is
enough room for the machine to pass through.
• Make sure that there are no bystanders or obstructions in the surrounding
area before moving off