ALMAC MULTI-LOADER 6.0 - Page 43

PAGE 43 ALMAC s.r.l.
No.
Identification
Function and Status
Description of the function
13
Selector
Longitudinal manual levelling.
14
Selector
Right rod manual levelling.
15
Connector
Auxiliary connector for places where radio frequencies
cannot be used.
16
Battery
Battery necessary for console power supply.
17
Cable
The cable is used in this particular condition:
- Use of radio remote control via cable (radio bridge by-
pass).
3.2.2 Ground control using the mobile push-button panel
The machine has been designed and built to be driven by an operator on the
ground.
The push-button panel works in radio control mode but in case of emergency it is
possible to connect the console using the cable supplied.
When operating, be careful not to come into contact with the platform tracks.
Stay at a safe distance.
3.2.3 Ground controls
The platform features a control console located on the chassis at the back of the
machine. These commands are for the operator in case of emergency situations
(red mushroom button).
Attention: The key must always be available.
1
3
4
2
5
6