ALMAC MULTI-LOADER 6.0 - Page 76

PAGE 76 ALMAC s.r.l.
6.1.2 Checks before each use
Prior to commissioning and before each use the machine must undergo the visual
and functional checks given below.
The instructions given below must be followed.
VISUAL CHECK
CHECK OPERATION
• Check that there are no traces of oil or
fuel leaks around and under the engine
(EVO - BI-ENERGY Version)
• Make sure that there is no hydraulic oil
leaking from the hoses and from the
other components (cylinders,
distributors, fittings, etc.).
• Check that there are no cut or worn
electrical cables and that the
connectors are correctly secured.
• Check the hydraulic oil level.
• Make sure that none of the screws,
bolts or ferrules are loose or missing.
• Make sure that all the pins are in place
and correctly secured.
• Make sure the tracks are not cut or
abnormally worn.
• Always check to make sure that track
tension is correct.
• Check that the manual, the plates and
the stickers are on the machine.
• Check that the steel structure is not
deformed.
• Make sure there are no cracks in the
welds, damage or abnormal wear.
• Check the fuel level before starting this
by avoiding work interruptions.
• Check the engine oil level.
• Position the machine with the frame inclined to
the horizontal with a value greater than 0.5°
on the side. Operate the automatic levelling
control and make sure that the system
automatically keeps the frame horizontal.
• Position the machine with the frame inclined to
the horizontal by a value greater than 0.5° on
the longitudinal. Operate the automatic
levelling control and make sure that the system
automatically keeps the frame horizontal.
• Position the machine with the frame inclined to
the horizontal at the maximum angle both on
the longitudinal and on the side. Operate the
automatic levelling control and make sure that
the system automatically keeps the frame
horizontal.
• Operate the emergency button on the remote
control; make sure that the machine is
switched off and that no function is permitted.
Release the mushroom-shaped button after this
test.
• Operate the emergency button on the ground,
check that the machine is switched off and
that no function is possible. Release the
mushroom-shaped button after this test.
• Operate the emergency buttons on the sides of
the machine, make sure that the vehicle is
switched off and that no function is permitted.
Release the mushroom-shaped button after this
test.
• Operate the warning buzzer and make sure it
works.
• Check the operation of the buzzer when the
drive function is activated.
• Check with the machine in translation (with
translation selector in DM) that releasing the
Joysticks the machine stops immediately.