Almaco Seed Spector LRX User Manual

SEED SPECTOR LRX MANUAL
21
$J - SET CYCLE COMMAND STRING
Syntax: $J(S)
Sets the CCS string. The string can be any combination of the following port
commands:
" S Set Relay
" Z Reset Relay
" W Wait
Where:
(S) is the command string (w/o leading “$”s)
Example: $JS02W300Z02W100S1W300Z1
NOTE: The $ is not included into string in the SS LRX Port Command S/W
Response: No response when a string parameter is sent. A $J with no string
parameter requests the
current $J string.
(S)<CR><LF>
$M – SET DEVICE GAIN FOR ANALOG CHANNELS
Syntax: $M(D)(V)
Where:
(D) is the device (channel) (0-7)
(V) is a desired value.
This command sets the GAIN parameter for the specified Device.
Note: See Legend for Device (D) location mapping
Response: M(D) = [current value > new value]<CR><LF>

Almaco Seed Spector LRX Specifications

General

Brand	Almaco
Model	Seed Spector LRX
Category	Control Systems
Language	English