SPC 20 OPERATOR’S MANUAL
D-8 TROUBLESHOOTING
Other mechanical problems Contact ALMACO
GROUND DRIVE
Fail-safe (parking) brakes
engaged
Disengage parking brake
Fail-safe (parking) brakes on Check charge pressure Speed
up engine
Hand control cable binding or
broken, worn cable ends
Lube cable, ends. Replace worn
parts
Torque hub(s) disengaged Replace torque hub caps
Component failure Contact ALMACO
Combine will not move
Insufficient charge pressure Contact ALMACO
If the problem does not appear in this section or if there are any questions on how to
proceed with a solution contact ALMACO.
To Next Page
Loading...