Alpha Moisture Systems dewTEC DS2000 User Manual

3.4 Setting the Alarms and hysterisis
Note, Alarm settings cannot be changed if the alarm
LOCK
is enabled in the hygrometer
program settings.
Edit mode for Alarm 1, Alarm 2 and hysterisis settings can be entered by pressing the scroll
key (
) when the parameter is displayed. This is the first step shown in the flow diagram
below. Follow the rest of the steps shown in the diagram to set your required valve.
PR
AL M 1
AL M 2
PRESS
1 Select required alarm or
hysterisis parameter
display. See paragraph 3.3.
2
PR
ALM 1
ALM 2
PR
ALM 1
ALM 2
Left-most digit flashes
PR
AL M 1
AL M 2
PR ESS
3
PR
ALM 1
ALM 2
Use the Down key to change
value of flashing digit if required
PR
AL M 1
AL M 2
4
PR
ALM 1
ALM 2
Next digit flashes
PRES S
5 Repeat steps 3 and 4 for each digit required
6 When adjustment is
complete, confirm new
value by pressing (
P
).
PR
ALM 1
ALM 2
PRESS
All digits will stop flashing
and new valve will be displayed.
Display is now back in operating mode
at the point where the setting mode was entered.
PR
AL M 1
AL M 2
PR
ALM 1
ALM 2
PRESS
To abort at any stage.
Note: if in edit
mode no key
activity occurs
for 90 seconds,
the hygrometer
automatically
returns to
operation mode
at the point
where the
setting mode
was entered
and cancels any
changes made.
dewTEC DS2000 User’s Manual Page 11

Alpha Moisture Systems dewTEC DS2000 Specifications

General

Brand	Alpha Moisture Systems
Model	dewTEC DS2000
Category	Measuring Instruments
Language	English