Alpha 9500 HF - Page 50

Alpha 9500 HF Linear Amplifier Operating Manual Alpha Radio Products
Operating the Amplifier Product Release 1
DOCNUMBER 9500
Document Issue 1, Revision 7
Page 6–10 June 2009
66
6
Procedure 6-3 Program the memory
Action Result
Step 1
Tune the amplifier to the desired frequency
i
n the User 1 or User 2 position and the
correct antenna port to be saved. Remember
that you cannot store in the default position.
Example: Tune to 14.025 MHz in User 1
segment 1.
Step 2
Press the S
AVE button (to the left of the
User 1/2 buttons).
The LED flashes once to
indicate that the
information has been
stored.
Step 3
If you use more than one antenna for a band,
rep
eat to store the additional antenna
information.
Example: You have one antenna on port 4
(beam) and
another on port 3 (vertical) and
both are resonant at 14 MHz. Store the beam
settings in User 1 antenna port 4 and the
vertical settings in User 2 antenna port 3.
Step 4
Move off the band and ensure that the
a
mplifier returns to the previous location by
pressing any other band button and rekeying
the amplifier on the just-programmed
frequency. If necessary, save the value
again.