Alpine Spas K2 - Startup and Refill Procedure

16
5. STARTUP & REFILL PROCEDURE
INSTALLING THE FILTER CARTRIDGES - FLOATING WEIR SKIMMER
FUJI,COLORADO,NEPAL,UTAH,NORDIC,ALASKA,YUKON
Filter(s)arefoundinsidethespapoolbutarenotpre-installed.
Grabthetoplidwithtwohands,
applylightdownwardspressure
andtwistanti-clockwisetodetach
(canbequitestiff).
Insertthelterandplaceitover
thecircularholdingpiecesoitsits
tight.
Liftoffthelidtorevealthebasket
grillunderneath.
Insertthebasketgrillintothetop
ofthelter,liningupthecircular
hole.
Liftoutthebasketgrillandplace
aside.
Pressthebasketdowngentlyto
ensureatightt.
Insidetheskimmerbox,seethe
circularholdingpiecethatthe
ltercartridgewillsitover.
Replacethetoplidbygently
puttingdownwardspressurewhile
turningclockwise,untilitsnaps
backintoplace.
1
4
7
2
5
8
3
6
AVOID DAMAGE TO SPA POOL & VOIDING WARRANTY - ONLY
USE FILTER CARTRIDGES PURCHASED FROM ALPINE SPAS.