Alpine Spas K2 - Startup, Priming, and Heating

18
SWITCHING ON & HEATING UP
5. STARTUP & REFILL PROCEDURE
Automatic Startup Procedure
Uponactivatingpower,thespapool’stopsidecontrolpanelshouldlightupandthe
screenwilldisplayaseriesofspecicsequencesandnumbers.
Ifthescreenisblankwhenyoupoweron,switchoff/onagain.
Priming
Thespapoolwillentera‘primingmode’wheneveritisrstinitiatedorrestarted.
Thisisstartupfunctionwhichwillrunthecirculationpumptoclearanyairinthe
plumbingfor20secondsatatime.
Thetopsidecontrolpanelwilldisplay“PRIMING”orsimilartoindicatethepriming
modestate.
Checkthatthecirculationpumphasengagedbyvisuallysightingmoving/rippling
waterinsidespapool.Watermayowfromthewaterfall(ifopenandequipped).
Iftheprimingfunctionfails,anerrormessage(likelytobeER3-WaterPrime)will
displayonthetopsidecontrolpanel-checkthetroubleshootingguideattheback
ofthismanualforassistance.
HEAT-UP PROCESS
Automatic Heating
Afterpriminghasnished,thespapoolisautomaticallyconguredtobegin
heating to 38
O
C.Thecirculationpumpwillengageandthespapoolwillbegin
lteringandheatingupautomatically.
Note:Adefaultsnoozetimerisinplacewhichdisablesfunctions(including
heating)between22:00–07:00.Thiswillslowinitialheatuptimeifnot
temporarilydisabled.Youmustsetthetime(clock)onthetopsidecontrolpanel
andthendisablethesnoozetimertoallowforafastrsttimeheat-up.
See pages 26-27.
Installing the Cover
Placeyourspapoolcoverontopofthespapoolandlockitdownbyinstallingthe
clips.Fullinstructionscanbefoundwiththeclipsandscrews,whichareattached
to one of the 8 hanging cover straps.
Heat Up Time
Dependingonenvironment,itcantakeupto12-18hourstoheatthespapoolto
thedefault38
O
C(orlongerifsnoozetimerwasnottemporarilydisabled).