EasyManua.ls Logo

Alpine 1980 - Pre-Season Preparation

Alpine 1980
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery
Remove battery from vehicle and clean
outside surface of battery with solution
of baking soda and water.
R~move
.all
deposits from posts then nnse with
clear tap water.
_ CAUTION: Do not allow cleaning
....
solution to enter battery interior
sinceit will destroy the electrolyte.
Check electrolyte level. Refill if neces-
sary with distilled water. Fully charge
battery. (A stored battery should be re-
charged at least every 40 days).
..,
CAUTION: Prior to charging the
...
battery, always remove it from
the vehicle to prevent electrolyte
spillage.
....
WARNING:
Gases given off by a
~
battery being charged are highly
explosive. Always charge in a weir ven-
tilated area. Keep battery away from
cigarettes or open flames. Avoid skin
contact with electrolyte.
Coat
electrical
connections
and
switches
with
a greaseless metal pro-
tector, if unavailable, use petroleum
jelly. Store unit in a cool! dry place.
22
Chassis
Clean the vehicle thoroughly! removing
all dirt and grease accumulation.
..,
CAUTION: Plastic alloy compo-
....
nents such as windshield, con-
sole, etc., can be cleaned using mild
detergents or isopropylalcohol. Do not
use strong soaps, degreasing solvents,
abrasive cleaners, paint thinners, etc.
Inspect cab and repair damage. Repair
kits are available at your authorized
Bombardier dealer.
Touch up all metal spots where paint
has been scratched off. Spray all bare
metal parts of vehicle with
metal pro-
tector. Wax the cab for better pro-
tection.
O
NOTE: Apply wax on glossy fi-
nish of cab only. Protect the ve-
hicle with a cover to prevent dust ac-
cumulation during storage.
...
CAUTION: If for some reasonthe
....
snowmobile has to be stored out-
side it is necessary to cover it
with an
opaque tarpaulin. This caution
will pre-
vent the sun rays affecting the plastic
components and the vehicle finish.
General
Inspection
Check electrical wiring and compo-
nents, retighten loose connections.
Check for stripped wires or damaged
insulation. Thoroughly inspect the ve-
hicle and tighten loose bolts! nuts and
linkage.