Alpine CD Shuttle Controller 7292MS - Basic Operation

OPERATION
@ BASIC OPERATION
Power Switch and Volume Control 8
Rotating
the
Power
switch
@9
clockwise
turns
the
power
ON
and
continuously
increases
the
volume.
Rotating
the
control
counterclockwise
will
continuously
decrease
the
volume,
and
turn
the
power
OFF.
NOTE:
Keep the volume control turned fully counterclockwise before your program starts.
Adjust
the
volume
by
gradually
turning
the
control
clockwise
once
playback
begins.
Do
not
turn the control clockwise abruptly as the excessive power could damage the speakers.
Balance Control 69
Pull on the Volume control @9 and rotate to balance between left and right speakers.
Fader Control
Rotate the Fader control @ for your desired front to rear volume balance.
Separate Bass and Treble Controls (©, @)
Slide
these
controls
to
the
right
to
increase,
and
to
the
left
to
decrease
the
level
of
Bass
or Treble.
LOUDness
Press the LOUD switch 6? for more than two seconds to activate the loudness function.
Press the LOUD switch again for more than two seconds to defeat this feature.
Mode Switching of the 7292MS
1. Radio Mode
Press the TUNER button © to put the unit into the radio mode. The Band indicator
(FM, MW or LW) will appear in the display.
2. Cassette Player Mode
Press the TAPE button @ to put the unit into the cassette player mode.
3. CD Shuttle Mode
Press the DISC button @ to put the unit into the CD mode.